Post by David BillingtonPost by Peter FairbrotherPost by David BillingtonPost by Peter FairbrotherAnyone know a source? 1/8 x 3/64 would do.
thx
Peter F
Peter,
What about this on Amazon
https://www.amazon.co.uk/Copper-Round-Thickness-Straight-Hollow/dp/B0848H9DPW
. How much do you need.
Don't know why I didn't find that, thanks.
Unfortunately the price is a bit high as I was looking for a 30' coil,
not 300mm - but still useful for a trial.
Thanks!
Peter
Peter,
At least it shows it's out there, more digging likely required to
find a source for longer lengths if it ends up being required.
There's a very handy welding/brazing rod available - goes under the
moniker of 'Silbralloy'.
You butt the two ends together, heat to red, apply end of rod, and in a
flash, it runs round and joins copper things. When the joint is cleaned
you can't see the join.
I use it for joining copper water pipe amongst other things: "Look! No
joints!"
Other metals are available.
--
Rusty Hinge
To err is human. To really foul things up requires a computer and the BOFH.